The popularity of reflectors has grown by leaps an bounds in the past year. These reflectors give hotspot users a way to access NXDN talkgroups, and speak to other hotspot users. However, there are some important steps you must take, to ensure your reflector\/talkgroup can also be heard on NXDN repeaters throughout the country.<\/p>\n\n\n\n
STEP ONE:<\/span><\/strong> Configure your reflector’s NXDNreflector.ini file Any lines that start with a “#” can be left as-is. That symbol signifies a line that is commented-out, and will be ignored. Restart your reflector when done.<\/p>\n\n\n\n If you have any other lines that begin with “Address,” you must put a pound sign at the beginning of those lines. Failure to do so may cause conflicts in the network.<\/strong> Unused address lines can simply be deleted, if desired.<\/p>\n\n\n\n <\/p>\n\n\n\n STEP TWO:<\/span><\/strong> Notify the Core admins The popularity of reflectors has grown by leaps an bounds in the past year. These reflectors give hotspot users a way to access NXDN talkgroups, and speak to other hotspot users. However, there are some important steps you must take, … Continue reading
Locate the Icom Network section of your .ini file, and configure it as follows:<\/p>\n\n\n\n[Icom Network]<\/td><\/tr> <\/td> Enabled=1<\/td><\/tr> <\/td> Address=flicom.nxcore.org<\/td><\/tr> <\/td> TGEnable= <your talkgroup ID here><\/td><\/tr> <\/td> # TGDisable=3456<\/td><\/tr> <\/td> Debug=0<\/td><\/tr><\/tbody><\/table><\/figure>\n\n\n\n
<\/p>\n","protected":false},"excerpt":{"rendered":"